How To Correct A Leaning Tree With Support
Learn how to straighten and support a leaning tree with expert advice on tree staking, guying and long-term tree care.
16.08.2026
When planting a tree, there are a couple of different schools of thought when it comes to staking and tree support. Some say that staking provides the tree with support until its anchor roots develop. Others claim that the to-and-fro motion of a free swaying, unstaked tree will strengthen the roots, leading to a sturdy tree.
In this guide, the Two Thirsty Gardeners share their experience of growing and caring for cider apple trees. In particular, a Kingston Black which unfortunately suffered from the gusts of winds that rip through their exposed allotment site and subsequently developed an unfortunate lean:
We went for the tough love approach, forgoing the stake because:
a) We were in a rush to plant the trees and
b) We forgot to buy stakes.
This technique worked well for the other apple trees we planted, but the windy conditions up at the plot proved a bit too much for our beloved Kingston Black.
Before the next stormy spell knocks it flat, we have attempted to make amends for our neglectfulness and offered up maximum tree support by both staking and guiding.
Here are our suggestions for how to do both:
Guiding a tree
First off, we’re going to guide rope the tree. Guiding is the easiest, most secure way to offer support to trees that are already established – just the ticket then for our wonky tree. Staking alone might be enough to rectify the problem, but we are going for a ‘belt and braces’ approach.
- Choose your rope. You want to use something at least 4mm thick that doesn’t stretch under duress. Cut a 30cm length of old hose and thread your guide rope through the middle. (Or slice open the side of the pipe and retro-fit it if you forget. Like us) This will prevent the rope biting into the tree and damaging the bark.
- Gently raise up your tree (this is easier with two people, so enlist help from a pal) to a point where the trunk is as vertical as you dare. A cracking, splitting sound at this point is bad news…
- Wrap your rope around the trunk and fix it to the ground with a sturdy peg. You’ll want to peg it out at a distance of at least four foot from the base of the trunk for maximum stability. Be aware of the tripping hazard you are creating, so try to use a bright coloured guide rope to head off any potential accidents.
Staking a tree for support
There are various methods of staking a tree, but because we want to avoid damaging the established roots, we’ll be using the angled stake method.
- Inspect the stake for knots and cracks before purchase. Any faults will be magnified when you hammer it into the ground, especially if the earth is frozen or rocky.
- Angle your stake at 45 degrees, with the blunt end pointing into the lean. Upright stakes are usually positioned between the tree and the most likely direction of the wind, to prevent the tree rubbing up against the stake. Because our tree is leaning at such an acute angle, we want the stake to be pushing the tree back, like a rugby prop forward leaning into a scrum.
- Secure the tree to the stake with a soft, rubber tree tie. Remember that ties need to be loose enough to allow for growth, so make sure you go for one that you can adjust easily.
We plan to leave the stake and guide in for at least one growing season, by which time we expect the roots to have spread sufficiently to enable the tree to stand upright without our woody/ropey additions and be as magnificent as the others!
Two Thirsty Gardeners bio
The Two Thirsty Gardeners, Rich and Nick, are bloggers who love gardening, eating and drinking in equal measure! They love to share tales from their allotment including their experiments turning the spoils of their crops into alcohol, both the good and the bad! To find out more about Rich and Nick, click here.
